Mercury 1.1 Printed Double Shear Stepper Bottoms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mercury 1.1 Printed Double Shear Stepper Bottoms
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed Double Shear Stepper Bottoms - I modified the Nebula stepper bottoms to friction fit a F695-2RS bearing. If your stepper shaft is long enough, it should slide right in and give you double shear. No other parts need to be modified. I am using some StepperOnline motors with 55mm shafts and I think 40mm will just barely work, but it would be safer to go 42mm or longer. You can use these without a Nebula frame, you just will not have the extra extrusion length to mount the most rear bolt, and that is fine.
Also, if you don't mind, post a make and provide some feedback. I would love to see if anything I am doing is helping someone else. Thanks! Happy printing.