96W MacBook Charger PegBoard holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pegboard Macbook charger holder
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a custom DIY made Pegboard for my work desk and the holes on the board have have non-uniform holes over the whole wall. While measuring I found that the closest I can get is some holes are separated 25mm apart from each other if measuring from the middle of the hole. I made a bunch of different holders for tools I have. All of the uploaded holders are made for holes that fit only boards that are at least 5.2mm in hole size and 25mm apart from each holes center. Photos of measurements and fitting are provided.I recommend PETG for strength and printing the model standing up which needs supports under the pegs . This will give the needed strength for the holder to hold the weight required without breaking.