Waveshare ESP32-P4 Case (optional camera mount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Built for ESP32-P4-Module Devkit by Waveshare Optional camera mount, GPIO Holes, and button/port access
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 202
- Wydruki
- 1
- Wyświetlenia
- 1054
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
ESP32-P4 Case
Built for ESP32-P4-Module Devkit by Waveshare
Offers optional camera mount, GPIO Holes, and button/port access
What to print?
Without camera mount:
Bottom
Cover-hex
With camera mount:
Bottom
Cover-hex Camera
CameraMount
Required parts
4x m3 screws (minimum 8 mm) for screwing ESP32-P4 into case
Optional camera mount: 1x m2 screw (min 10mm, 16 mm recommended), 1x m2 nut (optional)
Notes for printing
The "Cover-hex Camera" is a pain to print, as it has to be printed with support.
Printing upright (Rotate 90° on X-axis): Print it standing upright with support for the tabs and mounts. This. If your printer and filament has bad adhesion, consider adding/painting support to the sides of the cover about mid way from the bottom to the top.
Printing flat: Print it with support orienting the top surface upwards, as the support will likely make the surface of the bottom ugly.
Based on Raspberry Pi 5 Case by Stamos (https://www.printables.com/model/742926-raspberry-pi-5-case)