Outdoor Enclosure for Govee Light Controller | TPU Gasket | Dual 6 mm Cable Pass‑Throughs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PETG case with TPU gasket; dual passthroughs for 2×6 mm cables; M3×8 screws and heat‑set inserts.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 342
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Give your Govee string‑light controller (e.g., Govee Xmas Lights) a more weather‑resistant home. This printable enclosure uses a compressible TPU gasket and dual cable pass‑throughs to improve outdoor durability over the stock control box.
Features:
Dual cable gasket supports 2×6 mm OD cables (or smaller)
Lid secured with four M3×8 mm screws
Bottom half prepared for four M3 heat‑set inserts
Designed for 4 perimeters for better sealing and strength
Enclosure intended for PETG; gasket prints in TPU
Notes:
No formal IP rating; weather resistance depends on print settings, filament, and assembly
Check your controller’s dimensions/revision before printing to ensure fit
Materials:
Enclosure: PETG
Gasket: TPU
4× M3 heat‑set inserts
4× M3×8 mm screws
Optional: thin smear of silicone grease on gasket/cables for improved sealing
Printing/assembly:
Print enclosure in PETG and gasket in TPU
Use 4 perimeters as designed
Install heat‑set inserts in the bottom half, seat the gasket, route cables, then tighten screws evenly (do not overtighten)
Use at your own risk. I use it for low voltage use cases - for mains volage a ceritified enclosure with a IPxx rating is the safer choice.