Wera Toolcheck magnetic wall holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is for users who do not have a HSW or Skada/multiboard system and can drill two holes in a flat surface.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Share Alike
Designed so that I can quickly grab my toolcheck plus or snap it back into place, it features 8x standard neodymium magnets that are stacked in two spots.
The print is very quick and uses a minimal amount of filament. Tested in ASA with a 0.4mm nozzle.
First screw or rivet the print in place on a wall, you could even nail it to wood if that was necessary.
Add two stacked and glued magnets on each cutout for strength. I tuned the print to not need glue, but you can also superglue them in place. There are cutout in the back in case you need to press out a magnet if you break one or need to replace it.
Rough up the surface of the Toolcheck, magnets and superglue stick better if you sand it a little bit. I also drilled some very small holes to increase adhesion.
Use the magnets to align the second set of magnets on the side of the Toolcheck. They were originally designed to be 125mm apart, but I think i changed that in a later revision.
Please see my other modifications to the ToolcheckPlus on printables.