MagSafe Phone Mount for 2022+ (VB) WRX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wedges in-between two trim panels and holds a MagSafe charger on a ball mount
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 1030
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a printable mount for a MagSafe charger on a 17-mm ball head to hold it in a convenient position within a 2022+ Subaru WRX (VB). This is designed for left-hand drive (North American) models, but I would imagine mirroring it could make it work for the right-hand drive VBs!
Ball mount I used, but any 17-mm one will work with a 1/4"-20 female socket: https://www.amazon.com/dp/B08X7J9D5Z?th=1
MagSafe charger (I repurposed an older Spigen one but this one will do you fine): https://www.amazon.com/dp/B08HNBHSQV
I would recommend printing it upright so the layers run across the thinnest part of the joint. Mine is printed in PLA for now and if I have issues in the summer heat I'll reprint it out of ASA. Holds really well so far, though!
If the MagSafe charger is slipping against the smooth ball head, try scuffing it with some fine grit sandpaper and wrap its threads with Teflon tape. I found the tape adds some bulk in-between the threads and forces the flexible socket around the ball head just a bit tighter than otherwise.