CM3588 Plus To MicroITX Adaptor Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows mounting of a FriendlyElec CM3588 Plus NAS board into a regular PC case.
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 85
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This plate bolts onto a standard ITX (and thus ATX) backplate of a computer and allows you to install a FriendlyElec CM3588 PLUS NAS board in place.
I have made sure the backplate alignment and mounting holes for the CM3588 are raised enough to clear the heads of any screws used to mount the adapter to the tray. Edges are chamfered, the expanding holes for the motherboard standoffs are likewise angled to make printing easier.
Have tested on my Elegoo Centarai Carbon with both PLA and PETG, and both print perfectly well.
Holes to mount the CM3588 take 4.2mm heat inserts (a slim iron is recommended for the ones near the backplate).
I would highly suggest using an internal adapter for powering the CM3588: Aliexpress link
From the picture, a 6-port SATA controller can be installed to give a LOT of storage: Aliexpress link