EVA 3 Standard Bottom Horns Cartographer Probe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EVA 3 Bottom Horns with Cartographer mount. M3 heatset inserts. Compatible with low-profile V3/V4 probes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the standard EVA 3 Bottom Horns (non-Volcano hotends) with an integrated mount for the Cartographer touch probe using M3 heatset inserts.
Key Features
Drop-in replacement for standard EVA 3 bottom horns
Secure M3 heatset insert mounting system
Optimized probe positioning for reliable bed mesh scanning
Compatibility
EVA 3 platform (non-Volcano hotend configurations)
Cartographer low-profile probe (requires desoldering the connector header to achieve proper clearance!)
V4: Very good clearance
V3: Will slightly bend unless you shorten a few of the pins, but works just fine
Probe Configuration
The mount positions the Cartographer probe with the following offsets (ready to use in your printer.cfg):
[cartographer]
mcu: cartographer
x_offset: 0
y_offset: 23.5Z-distance to nozzle tip: 2.75mm (designed clearance)
Assembly Notes
Install M3 heatset inserts before mounting the probe
Secure probe with M3 screws (anything between M3x4 and M3x6; ≥M3x5 will protrude slightly into the duct)
Credits
Original EVA 3 Bottom Horns design by the EVA team