1 / 4
Part to make your TBS Mojito  NOT FLY OUT OF THE SKY LIKE A BRICK — zdjęcie 1
1 / 4

Part to make your TBS Mojito NOT FLY OUT OF THE SKY LIKE A BRICK

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Do you have a TBS Mojito FPV wing? Please check this print out to keep it in one piece! :D

Ocena
0 / 5
Polubienia
7
Pobrania
136
Wydruki
0
Wyświetlenia
584
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

The TBS mojito FPV wing has some issues... Especially in the connection of the wings. These parts are designed to:

  • Solve issue of wrong connector engagement (spacer)

  • Solve issue of wing detaching with turbolence or vibrations

The wing latches MUST contain a HEX nut that should be inserted mid-print with a pause. Please print them standing as they will be used in the wings. You will see the hole for the nut in your slicer :)

When gluing the TAB in the fuselage please use an exacto knife to start the hole and then dry test fit it without glue. Draw a line on how deep it should be inserted and only after glue it in.

Tagi