Miniature Aviators - Fits Labubu - Quick - Snug Fit - Optional Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Miniature Aviators designed for Labubu. Fast 25 minutes. Easy to remove supports. PLA tested and optimized for quality.
- Ocena
- 4,5 / 5
- Polubienia
- 47
- Pobrania
- 269
- Wydruki
- 2
- Wyświetlenia
- 564
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Quick Facts
Design: Custom-designed Aviators specifically sized for Labubu dolls with a snug, secure fit.
Speed: Quick print that completes in approximately 28 minutes.
Quality: Optimized with variable layer height for high detail where it counts.
Printability: Uses minimal supports that are designed to be easy to remove.
Printing Specs
With Supports (Recommended)
Print Specifications
Specification | Value |
|---|---|
Estimated Print Time | 28 Minutes |
Filament Used | 2.1 g |
Layer Height | 0.08 mm |
Wall Thickness | 1 perimeters |
Infill Density | 15% |
Supports Required | Yes |
Adaptive Layer Height | Enabled |
Nozzle Diameter | 0.40 mm |
Settings Used
This Print: PLA • 1.75mm • 205°C Nozzle • 55°C Bed
Print Notes
Optimized for Ender 3 V2 with BLTouch bed leveling
Uses off-print purge line to prevent nozzle blobs
Exported from PrusaSlicer
⚠ Adjust temperatures +/-5C if experiencing adhesion or stringing issues
Recommended: Test on a small print first before large jobs
Without Supports
Print Specifications
Specification | Value |
|---|---|
Estimated Print Time | 23 Minutes |
Filament Used | 1.9 g |
Layer Height | 0.08 mm |
Wall Thickness | 1 perimeters |
Infill Density | 15% |
Supports Required | Yes |
Adaptive Layer Height | Enabled |
Nozzle Diameter | 0.40 mm |
Settings Used
This Print: PLA • 1.75mm • 205°C Nozzle • 55°C Bed
Print Notes
Optimized for Ender 3 V2 with BLTouch bed leveling
Uses off-print purge line to prevent nozzle blobs
Exported from PrusaSlicer
⚠ Adjust temperatures +/-5C if experiencing adhesion or stringing issues
Recommended: Test on a small print first before large jobs