Ender 3 V2 PSU Cover flat bottom 92mm Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PSU Cover which can be printet on Ender 3 V2 without much support
- Ocena
- 4 / 5
- Polubienia
- 28
- Pobrania
- 168
- Wydruki
- 5
- Wyświetlenia
- 2546
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Origianly I just wanted to use the referenced model.
I did print it standing sideways on my Ender 3 V2, wich used a huge amount of support and the screw holes didn't fit to my power supply.
So I redesigned it from scratch.
Advantages of my design
- able to print it flat on the Ender 3 v2
- flat bottom to print nearly without supports (one corner needs a tiny bit touching the buildplate)
- able to use infill pattern as mesh for better air flow - and better looks ;)
- still fit a Noctua A9x14 PWM fan (NOT a 92mm x 25mm fan)
To get the mesh optic use the following settings:
(I got the idea from: https://www.thingiverse.com/thing:4653994)
- Top Layers = 0
- Bottom Layers = 0
- Infill Density = 50%
- Infill Pattern = Triangels
My PSU cover doesn't cover everything like the original sheet metal.
The PSU is fully covered, but the cables at the bottom are still visible.
This is due to the fact that i wanted to be able to print it with the Ender 3 v2 for itself, so the length of the bed was my limit.
Versions
- normal version 92x14, for Nocuta fan
- version with cable support 92x14, which adds two calbe supports to the back of the → shown in pictures
Ground Clearence
You need to raise the printer for this cover, because the original feet aren't high enough.
These are designed for this cover (you have to use the V2 raised version): https://www.prusaprinters.org/de/prints/152248-ender-3-v2-squash-ball-feet
I repeat the good advice from chilluniverse:
The design has air vents and uses a bigger fan compared to the original Cover of the PSU thus more general ventilation takes place even when the fan is not spinning. So don't freak out if your fan is not spinning as long and often like the original one does.
Print Settings
Printer: Ender 3 V2
Supports: Yes - touching Buildplate
Resolution: 0.36
Infill: 50% Triangles
Filament: PLA
Top Layers = 0
Bottom Layers = 0
Infill Density = 50%
Infill Pattern = Triangels
Support = touching Buildplate
Category: 3D Printer Parts