Ender 3 TFT35 USB Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The USB on the Ender 3 TFT Display is a bit fragile, and will likely snap if you bump it in a bad way.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The USB on the TFT E3 is a bit fragile, and if you were to accidentally bump your USB stick while its inserted (like I did) it will probably come loose or break off. I designed this to hold the USB in place if you cant reattach it any other way. Unsure why the Thingiviw will not generate
CAUTION: Tolerances are very tight. Be very careful. I've updated a newer version that should be a bit more lose around the edges of the USB and SD slot, but haven't tested it. Clip/sand down the corners if needed
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
15%-25%
Notes:
Probably doesn't need supports, but it's so small there really is no harm in tossing them. only about 30 minutes at 60mm/s
Category: 3D Printer Parts