Ender 3 TFT35 USB Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The USB on the Ender 3 TFT Display is a bit fragile, and will likely snap if you bump it in a bad way.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 12
- Makes
- 0
- Views
- 288
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
The USB on the TFT E3 is a bit fragile, and if you were to accidentally bump your USB stick while its inserted (like I did) it will probably come loose or break off. I designed this to hold the USB in place if you cant reattach it any other way. Unsure why the Thingiviw will not generate
CAUTION: Tolerances are very tight. Be very careful. I've updated a newer version that should be a bit more lose around the edges of the USB and SD slot, but haven't tested it. Clip/sand down the corners if needed
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
15%-25%
Notes:
Probably doesn't need supports, but it's so small there really is no harm in tossing them. only about 30 minutes at 60mm/s
Category: 3D Printer Parts