Yet Another Filament Dry Box (for Yashe 3.7L jars)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
no drilling needed; built-in silica container and hygrometer holder; spool rolls on 608 bearings
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 1137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Needed hardware
x2 608 bearings (22mm ext-diameter, 8mm int-diameter, 7mm thick)
x6 M3x12 screws
x6 M3 threaded inserts
x1 M5 threaded insert (optional)
x1 (or x2) PC4-M5 quick couplers for 4mm PTFE tube (optional)
PTFE tube
x1 thermometer/hygrometer (optional)
M8 washers to adjust to the spool width
Print settings
filament stopper:
TPU
0.2mm layer height / 10% infill
All other parts:
PETG
0.2 mm layer height / 15% infill
100% infill for the axis on the arms and for the narrow sides of the main body (c.f. screenshot)
Assembly: flanges
gently break the flanges fins built-in supports one by one
push the bearings in place (tolerances are tight)
squeeze the flanges on the center of the spool
Assembly: box
push the x6 M3 heat threaded inserts into place
screw the 2 arms and the sensor holder with x6 M3x12 screws
push the hygrometer into place
install the original gasket from the box's lid on the main body
fill the silica container and push carefully everything into the lid
install x0, x1 or x2 quick couplers and the PTFE tube
(alternative: you can skip the couplers if using the filament_stopper_nocoupler part)
To install the spool, add as many M8 washers on the x2 axis until the spool gets fully blocked laterally by the box.
Spool compatibility
Tested with:
spool width: between 55mm and 67mm
center hole diameter: between 52mm and 57mm
Large spools (such as AmazonBasics 75mm ones) won't fit in those box (whichever the design).
Smaller or larger hole diameter would require a remix of the central flange.