STM32 Nucelo-64 case with lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact, protective case for the Nucleo development boards, with miniUSB
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Overview
This is a compact and lightweight case designed for Nucleo development boards. Key features include:
Protective Top Cover: Features a latch to protect against dust, loose debris, and accidental pin bending.
Safety Hinge: The rotation angle is locked at 110 degrees to prevent damage to the USB connector.
Electrical Safety: Pins are electrically isolated from the housing.
Forgiving Fit: Designed with a +0.4 mm tolerance for the PCB.
Bill of Materials
4x M3 Heat Inserts (5x3 mm)
4x M3x4 SHCS Screws*
*The 4 mm length is required for the hinges. For mounting the board itself, screws can be up to 8 mm long.
Print Settings
Tested on Bambu Lab P1S with Sunlu PLA:
Layer height: 0.2 mm
Walls: 2
Infill: 15%
Other materials and standard parameters should work fine.
Assembly
Due to the small surface area, the hinge may deform if not cooled properly. Drill the holes out if necessary
Installation: Install the heat inserts flush with the plastic surface and screw the parts together.
Adjustment: You can adjust the cover's friction by tightening the screws. If the latch is too tight, trim it slightly with a hobby knife
Compatible Boards
F303RE
...
Please let me know in the comments if you test this with other Nucleo boards