STM32 Nucelo-64 case with lid
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Compact, protective case for the Nucleo development boards, with miniUSB
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 53
- Makes
- 0
- Views
- 229
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Overview
This is a compact and lightweight case designed for Nucleo development boards. Key features include:
Protective Top Cover: Features a latch to protect against dust, loose debris, and accidental pin bending.
Safety Hinge: The rotation angle is locked at 110 degrees to prevent damage to the USB connector.
Electrical Safety: Pins are electrically isolated from the housing.
Forgiving Fit: Designed with a +0.4 mm tolerance for the PCB.
Bill of Materials
4x M3 Heat Inserts (5x3 mm)
4x M3x4 SHCS Screws*
*The 4 mm length is required for the hinges. For mounting the board itself, screws can be up to 8 mm long.
Print Settings
Tested on Bambu Lab P1S with Sunlu PLA:
Layer height: 0.2 mm
Walls: 2
Infill: 15%
Other materials and standard parameters should work fine.
Assembly
Due to the small surface area, the hinge may deform if not cooled properly. Drill the holes out if necessary
Installation: Install the heat inserts flush with the plastic surface and screw the parts together.
Adjustment: You can adjust the cover's friction by tightening the screws. If the latch is too tight, trim it slightly with a hobby knife
Compatible Boards
F303RE
...
Please let me know in the comments if you test this with other Nucleo boards