1 / 1
ResMed Spiral CPAP Tubing Repair or Extender — zdjęcie 1

ResMed Spiral CPAP Tubing Repair or Extender

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Butt joins two sections of 23mm ResMed spiral CPAP tubing to either join 2 lengths or repair a hose broken in the middle

Ocena
0 / 5
Polubienia
18
Pobrania
33
Wydruki
0
Wyświetlenia
244
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

A joint for emergency repair of a broken CPAP hose, or to make your own hose extensions and adapters. Known to work with AirFit and Liberty tubes. Does not connect electrically heated tubing, but more effective than two feet of duct tape!

Screw a piece of 23mm ResMed CPAP tubing into each each end of the connector. It helps to neatly trim the end flat first if it was broken. A partition half way stops you from screwing one piece in past the middle. It's a tight fit to start with, so you'll need to be enthusiastic about flexing and squishing the tubing, but once you've got it in place it screws in pretty easily. If you use glue (and I haven't found that necessary), make sure it's one you don't mind inhaling the fumes from, personal responsibility and all that.

I print mine in TPU using PLA as a support material, as this is (a) more comfortable to sleep on, and (b) less likely to damage the tube. But it will print unsupported in PLA or PETG if that's what you have.

Keep one in your travel CPAP bag in case of accidentally slamming the darn hose in the bedside drawer...

The model source is supplied as an OpenSCAD file, and you are encouraged to tweak it for other makes of tubing or remix. Please share your makes and pass them on to The Four Thieves Vinegar Collective Open Medicine group.

If you break the mask or swivel connection off the end of the tube, this might help: 

Tagi