1 / 9
M50x1.5 Blind Stuffing + Nut and TPU-Sealing / M50x1.5 Blindstopfen + Mutter und TPU-Dichtung — zdjęcie 1
1 / 9

M50x1.5 Blind Stuffing + Nut and TPU-Sealing / M50x1.5 Blindstopfen + Mutter und TPU-Dichtung

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

M50 blind stuffing to close unused openings for M50/PG42 cable gland in housings (ca 50.0mm). Optional TPU-sealing.

Ocena
0 / 5
Polubienia
3
Pobrania
70
Wydruki
0
Wyświetlenia
117
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

M50x1.5 threaded blind stuffing to close unused M50-openings.
Unused PG42-openings in housings are also possible to close with this blind-stuffing set.

[1] Thread type:
  Metric tread

[2] Diameters for suitable openings:
  Diameters for M50x1.5 opening:
  a) threaded hole:                    48.5mm / M50x1.5 thread
  b) drill hole without thread:  50.0mm / no thread
  Diameters for PG42 opening:
  a) threaded hole:                   52.5mm / PG thread 
  b) drill hole without thread:  >54.0mm / no thread
  c) For a PG42 opening you can also use 
      https://www.printables.com/model/1506609-pg42-blind-stuffing-nut-and-tpu-sealing-pg42-blind
      as alternative .     

[3] Sealing:
  An optional TPU-sealing model file is available.

Print
Material:   PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim:         not required
Serial printing (part by part) for better thread quality.

Assembly
Threaded opening:
Screw the blind stuffing into the M50x1.5 opening.
Optionally place sealing on stuffing before assembly.
Unthreaded opening:
Place blind stuffing in PG42/M50 opening and secure with M50x1.5 nut.
If necessary, widen the opening to >=50.0mm before assembly.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.

Hint: 
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)

Tagi