Meshtastic Battery Tray & RAK4631 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Solar Meshtastic Node internal bracket system. Fits 10,000mAh battery & RAK4631 in 150x100x70mm outdoor junction box.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 472
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Meshtastic Battery Tray & RAK4631 Mount
Printed Mounting Brackets
This is a two-part mounting system for a Meshtastic Solar Node, designed to securely house a high-capacity battery inside a standard 150x100x70mm Waterproof IP67 Junction Box.
The design utilizes stacked mounting plates:
Lower Battery Tray: Mounts directly to the existing plastic standoffs of the junction box. It is sized specifically for a 10,000mAh MakerHawk LiPo battery.
Upper Mounting Plate: Screws into the standoffs on the battery tray, providing a secure platform for the RAK19007/RAK4631 WisBlock.
Key Features:
Integrated Antenna Slot: Dedicated holder for the flat internal Bluetooth antenna.
Wire Management: Built-in cutouts for clean routing of battery and solar power wires.
Secure Fit: Designed to prevent the battery from shifting while allowing enough room for wire leads.
Recommended Print Settings
Material: PLA (Tested for 4+ months in-enclosure without deformation). For extreme high-heat climates, PETG or ASA is recommended.
Layer Height: 0.2 mm
Infill: 15-20% (Pick your favorite pattern)
Supports: Not required
Walls: 3 or more
Complete Bill of Materials
To complete this build as shown in the photos, you will need the following components:
WisBlock: RAKwireless WisBlock Meshtastic Starter Kit (RAK19007 + RAK4631)
Battery: MakerHawk 3.7V 10000mAh LiPo Battery
Enclosure: Waterproof Outdoor IP67 Junction Box (150x100x70mm)
LoRa Antenna: Waterproof 5.8dBi Fiberglass Antenna
Pigtail Cable: IPEX U.FL to SMA Female Cable (6 Inches)
SMA to N Adapter: SMA to N Adapter Cable 12inch Low Loss
Solar Power: 7W Solar Panel for Security Camera
Hardware & Assembly Notes
To assemble this mount, you will need the following hardware:
Battery Tray to Box: Use the self-tapping screws that come included with the IP67 Junction Box to secure the lower tray to the internal standoffs. Use zip ties or wire wrap to secure the battery to the tray.
WisBlock to Upper Plate: The WisBlock Starter Kit typically includes the small M2.5 screws needed to secure the PCB to the mounting plate.
Plate to Plate: I used an assortment of small hobby screws to attach the upper mounting plate to the battery tray standoffs.