1 / 2
2 1/4"(2.25") to 2 1/2" (2.5") hose adapter for xtool f1/f2 laser engraver — zdjęcie 1
1 / 2

2 1/4"(2.25") to 2 1/2" (2.5") hose adapter for xtool f1/f2 laser engraver

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for an xtool f1/f2 laser engraver to let you use a 2.5" shop dust collection hose for venting the enclosure

Ocena
0 / 5
Polubienia
9
Pobrania
50
Wydruki
0
Wyświetlenia
194
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The hose that comes with the F1&F2 is kinda lame. I wanted to use a more rugged and standard shop vent hose but the dimensions are slightly off, so I made this adapter.

The wide end slips over the exhaust port on the back of the engraver. The narrow side goes inside the shop hose. Use a hose clamp to crank it down against the adapter and you are good to go!

If you print it in the orientation shown it won't require supports due to the angled sides. I used PETG.

Here's the shop hose I used: https://amzn.to/4slkq7S

Have fun!

Dave

Tagi