2 1/4"(2.25") to 2 1/2" (2.5") hose adapter for xtool f1/f2 laser engraver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for an xtool f1/f2 laser engraver to let you use a 2.5" shop dust collection hose for venting the enclosure
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 50
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The hose that comes with the F1&F2 is kinda lame. I wanted to use a more rugged and standard shop vent hose but the dimensions are slightly off, so I made this adapter.
The wide end slips over the exhaust port on the back of the engraver. The narrow side goes inside the shop hose. Use a hose clamp to crank it down against the adapter and you are good to go!
If you print it in the orientation shown it won't require supports due to the angled sides. I used PETG.
Here's the shop hose I used: https://amzn.to/4slkq7S
Have fun!
Dave