ETH Mod Case for Hak5 WiFi Pineapple Pager - Improved
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some users noted difficulty with unplugging cables from the ETH Mod. This updated model includes more clearance.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 513
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Some users noted difficulty with unplugging cables from the Hak5 WiFi Pineapple Pager ETH Mod. This updated the model has more clearance around the RJ45 Jack and will be preinstalled on all ETH Mods assembled January 2026 onward. Due to differences in printer calibration, some scaling tweaks may be needed for a tight interference fit of the two halves. Typical settings are 0.2mm layer height, no support, 3 walls. Keep in mind PETG has a higher shrink coefficient and may require slight scale adjustment than PLA.
WiFi Pineapple Pager Mods can be purchased at http://hak5.org/glytch
This case design is licensed under CC BY-NC-SA 4.0.
You are free to print and modify it for personal use only.
Commercial sale of this design or derivatives is not permitted.