Case for ESP32-C6 1.47inch Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple, tight-fitting case for: Waveshare ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 16
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 813
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A tight fitting case for the Waveshare ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 160MHz Running Frequency Single-Core Processor (Amazon 2025/12). Every case I found that matched this description was way too long and wide. This has an access hole for the USB-C at one end and channels so the BOOT & RESET keys are accommodated without being pressed. I printed this on a fine setting and the board/display fits in tightly so no additional glueing required. Warning - board might not come back out without a fight so be sure you are ready to install. There is a little extra space behind the main chip to allow for heat and I left a slim opening on the long edges so the status LED is at least detectable. This was going in a bathroom so I used PTEG but I am sure PLA and other filament types will work just as well.