Case for ESP32-C6 1.47inch Board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple, tight-fitting case for: Waveshare ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 16
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 108
- Makes
- 0
- Views
- 824
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A tight fitting case for the Waveshare ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 160MHz Running Frequency Single-Core Processor (Amazon 2025/12). Every case I found that matched this description was way too long and wide. This has an access hole for the USB-C at one end and channels so the BOOT & RESET keys are accommodated without being pressed. I printed this on a fine setting and the board/display fits in tightly so no additional glueing required. Warning - board might not come back out without a fight so be sure you are ready to install. There is a little extra space behind the main chip to allow for heat and I left a slim opening on the long edges so the status LED is at least detectable. This was going in a bathroom so I used PTEG but I am sure PLA and other filament types will work just as well.