1 / 5
TTArtisan 27mm F2.8 lens hood and cap — zdjęcie 1
1 / 5

TTArtisan 27mm F2.8 lens hood and cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improved square lens hood and cap for TTArtisan 27mm lens

Ocena
0 / 5
Polubienia
5
Pobrania
33
Wydruki
0
Wyświetlenia
189
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

This is a DIY lens hood and cap for the very capable TTArtisan 27mm F2.8 lens.  This has been tested on my Fuji X-T5, no vignetting has been detected. 

It is friction mount, grabs onto the periphery of the little lens hood that comes with the lens.  By design it goes on pretty stiffly, which is necessary since there's no actual bayonet for it to grab.  Friction only.

The hood is best printed in either fiber filled PET-G or Polycarbonate, this will help resist "creep" and loosening over time.

After printing slide the "latch" part through the slot in the cap, then affix in place using the "pin".   

Please check the photos for the best orientation on  your printer bed.

Comments are welcomed. 

Tagi