1 / 5
TTArtisan 27mm F2.8 lens hood and cap — image 1
1 / 5

TTArtisan 27mm F2.8 lens hood and cap

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Improved square lens hood and cap for TTArtisan 27mm lens

Rating
0 / 5
Likes
6
Downloads
33
Makes
0
Views
196
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is a DIY lens hood and cap for the very capable TTArtisan 27mm F2.8 lens.  This has been tested on my Fuji X-T5, no vignetting has been detected. 

It is friction mount, grabs onto the periphery of the little lens hood that comes with the lens.  By design it goes on pretty stiffly, which is necessary since there's no actual bayonet for it to grab.  Friction only.

The hood is best printed in either fiber filled PET-G or Polycarbonate, this will help resist "creep" and loosening over time.

After printing slide the "latch" part through the slot in the cap, then affix in place using the "pin".   

Please check the photos for the best orientation on  your printer bed.

Comments are welcomed. 

Tags