Convert IKEA BILRESA two-button remote into a decora-style remote switch using Wyza's screwless switch cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use PCBs from IKEA BILRESA two-button remotes to make a thinner, decora-style remote switch
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 1529
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Updated models for in-wall and with Wyza's faceplates
You probably want one of the updated models instead of this one.
The IKEA BILRESA two-button remotes are a very inexpensive way to add a programmable wireless switch to a smart home setup, including HomeKit. They are a fraction of the cost of, say, a Lutron Caseta Pico Remote, and easier to integrate into a generic HomeKit environment. But they don't look like a normal wall switch and they're kind of thick and bulky.
This model takes the PCB from the BILRESA and uses it with a decora-style paddle switch face, with the ability to put a normal-looking switch faceplate on, as an individual switch or groups of two or three, and is more than 4mm thinner than the BILRESA. These are designed to use these faceplates.
Alternatively, here's a different model that doesn't involve taking apart the BILRESA units.
Notes
When you take the PCB out of the BILRESA, there's nothing on the PCB that indicates what its Matter setup code is. It's probably a good idea to at least mark the 11-digit manual code on the back of the PCB (which is otherwise totally blank), to be able to use that or match it up with the Matter QR codes on the BILRESA case or manual.
Make sure batteries are oriented properly. There are + marks in each battery well.
The triangles on the front face point upward when the switch is oriented the same way it was in the BILRESA case.
The Toggle Paddle and Paddle Frame are symmetric, so there's no specific up or down.
The Toggle Paddle prints on edge for a smooth front surface. It may need mouse ears or a full brim to ensure that the ends don't lift during printing.
The holes in the back fit 8mm diameter 3mm thick magnets (tightly).
All parts are designed to print without supports.
Taking apart the BILRESA might void your warranty or burn down your house or something, so you're doing that (and everything else described here) at your own risk.