print-in-place Landing skids for DJI Mini 2, Mini 4K drone [UPDATED]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
print flat transport flat, folds into mountable configuration with detent to keep assembled, squeeze skids to mount.
- Ocena
- 5 / 5
- Polubienia
- 86
- Pobrania
- 576
- Wydruki
- 1
- Wyświetlenia
- 1646
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a 5 gram skid for use on a DJI Mini4K or Mini 2 lightweight drone. The skids weigh 5 grams and print easily; I used ASA but PETG or PLA should work too. The skids keep the props from mowing the grass when taking off and landing.
[UPDATE: After extensive trials including child participants, I updated the design so that the brace stays together better. Also, a friend ran our drone into a tree and broke one of the skids, so why not improve the design before re-printing it? ]
You can mount them unassembled and then place the brace in place to secure the skids, or you can pre-assemble it and then squeeze the skids to separate the tabs that go into the slots in the drone. Taking them off is the reverse. Because you can mount/unmount the skids by squeezing them, you could glue the brace to the skids if you didn't have any desire to disassemble it later.