Voron-Style Qi2 Magnetic Charging Stand (Pixel 10 Pro)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Voron-style Qi2 charging stand for Pixel 10 Pro. Features a weighted base and hidden cable routing.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 33
- Wydruki
- 1
- Wyświetlenia
- 273
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Voron-Style Qi2 Magnetic Charging Stand (Pixel 10 Pro)
Inspired by the industrial, functional design language of Voron 3D printers, I designed this desktop stand to take advantage of the new Qi2 wireless charging standard.
I created this specifically for my Pixel 10 Pro to reduce wear and tear on the USB-C port during daily use. The stand features a weighted base for stability and integrated cable management for a clean setup. While designed for the Pixel, it should work with any Qi2/MagSafe-compatible device.
🔩 Bill of Materials (BOM)
To complete this build, you will need the following hardware:
1x Baseus 15W Magnetic Wireless Charger Qi2
Ballast Material: Small lead balls, steel BBs, sand, etc. to fill the weight compartment.
🖨 Print Settings
Material: tested with PETG (PLA or ABS/ASA will also work).
Layer Height: 0.2 mm
Line Width: 0.4 mm
Infill: 20%
Wall Ordering: Inner-Outer-Inner (Important for dimensional accuracy).
Supports: Recommended for longer bridges.
Note: If your printer is well-tuned for bridging, you may be able to print this support-free.
🛠 Assembly Instructions
Print all parts: Refer to the screenshots for the recommended orientation on the build plate.
Post-Processing: Remove any supports and/or brims.
Prepare the weight container: Fill the hollow weight container with your ballast material (I used small lead balls).
Seal the weight container: Close the weight container using the printed screw plug.
Install Charger: Push the Qi2 charger into the main base part. It should fit snugly.
Route Cable: Snap the cable cover part into place to hide the wire.
Final Assembly: Push the weighted container into the base of the stand.