LED Light Forked Tilt Bracket (Yoke-Style, 1/4-20) – Replacement / Upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement tilt bracket for small LED panels and ring lights using standard 1/4-20 mounts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement tilt bracket for small LED panels and ring lights that mount to standard tripods or light stands using a 1/4-20 camera screw. The part is designed to be printed in PLA.
The lid does not require supports, but the main body does. Be sure to flip the main body upside down (forks facing upward) before slicing to ensure proper support generation.
I designed this after the original plastic tilt bracket that came with my NiceVeedi LED video lights cracked. The geometry, hardware interfaces, and dimensions match the common “mini tilt bracket” design used across many budget LED panels - it is not brand-specific and should work with any compatible light that uses a standard 1/4-20 mount and yoke-style tilt joint.
The lid is modeled with a very tight snap fit, allowing it to be used without screws if desired. Optional 10mm M4 x 0.7 screws are supported for permanent or high-load setups. A 1mm counterbore gap at the beginning of each screw hole allows for a bit of wiggle room on screw length.
The 1/4-20 screw adapter and adjustment wheel are not part of this model set. If anyone finds themselves in need of a good adjustment wheel replacement, reach out and I will model a custom adjustment wheel with threading that can fit a 1/4-20 headless camera screw. Original Fusion 360 project file will be made available upon request.