Switch 2 Cooling Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cooling stand for the Nintendo Switch 2 using a 120mm fan.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 346
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Just print with supports. When done remove supports and install 120mm fan. I just wired a USB cable into a fan capable of running at 5V. The fan pin with the arrow is ground (black wire of USB) and the middle fan pin in power (red pin of USB).
The design has sufficient tolerances so it should work regardless of printer resolution. The screw holes might be a little off. I got two in fine but the others took a little work. I just use wood screws since they will dig their way in.
I did not include a grill since there are tons of those available online.