IKEA Markus armrest handles (Easier printable remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small handles to replace the arm rests on an Ikea Markus
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original armrests on the Markus were not particularly comfortable for me and simply omitting them left me with ugly bolt holes and a hard-to-carry chair. These handles fixed both problems. You can use the original bolts or, if you accidentally disposed of them like me, M8x35 scews. ISO 14580 (flat cylinder head torx screws) are a really nice fit as the head sits flush with the print.
The original I remixed this from suggests the following print settings:
Layer height: ~0.2
Infill: ~25%
Perimeters: ~3-4 (@0.4mm nozzle)
Top and bottom layers: ~7
Support: Only needed for the bolt holes, suppress it everywhere else.
Brim: Can probably print them without, but probably a good idea to use them since bed adhesion surface is not very large.
I printed with 0.2mm layer height, 25% gyroid, 3 perimeters, 3 top/bottom layers, supports enabled and no brim. I had no issues with bed adhesion printing ABS on the satin sheet of a Core One. More top/bottom layers and more perimeters might make the screw holes more stable, so you can torque them down harder, but it seems to work regardless.