Jonsbo NV10 Front Panel (4 Versions)

Front panel with "mesh", blank, and diagonal variant. Image 1 showcases the mesh variant, with a version with some window screen glued on the back. Image 2 showcases just the mesh variant, and Image 3 showcases the blank

Updated 14 Jan 26. Fixed issue related to model bed adhesion (mesh was .1mm off, this was from when I made the base), also removed the "X" from the mesh design. 

Updated 23 Jan 26. Decreased thickness (to 2.5mm), increased outer brim width by 1.5mm on short sides (3mm total added), increased thickness of pin heads by 1.5mm in diameter, shortened pins by 1mm, updated mesh to look more even

Updated 24 Jan 26. Added a diagonal variant, slats are 5mm in diameter, positioned approximately 5mm apart from each other at a 45 degree angle

Updated 25 Jan 26. Added a diagonal variant with less slats, but wider at 7.5mm

Updated 27 Jan 26. Above variant's model was corrupted, reuploaded

Edit: I unfortunately do not have the .STEP files for when this was printed and I currently don't have the same setup so I apologize.

To anyone struggling with printing:
- For bed adhesion, if you're using ABS/ASA, you can use a raft ( .3mm usually works best for me) to prevent warping