Specialized Stix to Headlamp Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
And easy way to add a rear light to a headlamp.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 1042
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
I'm an avid cyclist, and my rear light of choice is the Specialized Stix (https://www.specialized.com/us/en/stix-elite-2-taillight/p/173394?searchText=49120-2100&color=270193-173394). These have multiple light modes, are bright, and have multiple flash modes.
I also like to walk in the evenings. Being that I live in a rural area, there are not a lot of sidewalks, so I'm often walking on the edge of roads or on dirt paths without street lights. To that end I often walk with my headlamp (https://www.batteryjunction.com/energizer-hdl2bodbp.html) or with an Olight SRII Baton (https://olightworld.com/olight-s1rii-baton). Neither of these solutions makes me visible from behind, but the Specialized Stix rear red light does. So for a couple of minutes of print time and I can add the Stix to my headlamp, and be seen for close to a mile.
This design should support bands between 18 and 21mm wide, up to 2mm thick.
Printing Parameters
- 0.15mm or better, in Quality is strongly suggested.
- PLA, PETG, or ABS should be fine. Also should print fine in resin.
- The 3MF file is pre-supported. I'd suggest following those as an example.
Going Forward
I'd really like to see what this looks like in resin, if anyone in the community prints it!