Specialized Stix to Headlamp Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
And easy way to add a rear light to a headlamp.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 65
- Makes
- 0
- Views
- 1,042
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
I'm an avid cyclist, and my rear light of choice is the Specialized Stix (https://www.specialized.com/us/en/stix-elite-2-taillight/p/173394?searchText=49120-2100&color=270193-173394). These have multiple light modes, are bright, and have multiple flash modes.
I also like to walk in the evenings. Being that I live in a rural area, there are not a lot of sidewalks, so I'm often walking on the edge of roads or on dirt paths without street lights. To that end I often walk with my headlamp (https://www.batteryjunction.com/energizer-hdl2bodbp.html) or with an Olight SRII Baton (https://olightworld.com/olight-s1rii-baton). Neither of these solutions makes me visible from behind, but the Specialized Stix rear red light does. So for a couple of minutes of print time and I can add the Stix to my headlamp, and be seen for close to a mile.
This design should support bands between 18 and 21mm wide, up to 2mm thick.
Printing Parameters
- 0.15mm or better, in Quality is strongly suggested.
- PLA, PETG, or ABS should be fine. Also should print fine in resin.
- The 3MF file is pre-supported. I'd suggest following those as an example.
Going Forward
I'd really like to see what this looks like in resin, if anyone in the community prints it!