Lilygo ttgo t3 v1.6.1 double 18650 battery case (+ bigger antenna hole and sdcard slot)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
case for the lilygo board and 2 18650 (or any battery holder with the same footprint)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 324
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked the original case but my antenna is much bigger than the default one, so i used the opportunity to make it thicker (so that the batteries fit) also add a second battery(wich works sort of like an handle), these are the battery holders i used https://.aliexpress.com/item/1005006283625827.ht , and a hole for the microsd slot, the bms is attached with double sided tape and i used a drill to add the hole for the button (i decided for it after printing it and didnt want to redo everything)
to hold the board i used 2 very small screws for plastic, regarding the on/off switch you can use the one from the original case, i just had to print it slightly longer as it didnt reach the board's switch too well