Creality K1 SE Rear Cable Chain Mount

This is a remix of pererry’s Creality K1 SE Cable Chain Mount, which served as the foundation for this design.

📌 QUICK OVERVIEW

• Designed for Creality K1 SE
• Enables clean cable chain routing similar to the K1C
• Replaces the stock cable/PTFE arch with controlled routing
• Allows use of risers and top covers
• Works as part of a multi-model cable chain solution

This remix focuses on improved wire routing, mounting strength, and long-term durability while maintaining compatibility with the original concept. If you prefer the original design approach, I encourage you to check out the original model as well — it’s a solid solution.

This model is designed to be used alongside the following for a complete cable chain setup:

•  Creality K1 Cable Chain Sagging Fix by ViniS
•  Cable Chain Link with PTFE tube Guide by C3D Garage
•  Creality K1SE Chain Link Riser by Protius (shameless self promotion)

🔧 PRINTING NOTES

Printed examples were done in PLA, but PETG or ABS may also be used if preferred.

Recommended settings:

• 0.4 mm nozzle

• Standard layer heights (0.2 mm works well)

• Default wall and infill settings

Supports:

• The main bracket and screw cover should be printed with supports.
• The rear support bracket and chain link can be printed without supports.

🔩 REQUIRED HARDWARE

Main Bracket:
• (2) M3 x 5mm Heat Set Threaded Inserts

Rear Support Bracket:
• (1) M3x10mm Flat Head screw (replaces factory screw to attach it to the frame)
• (2) M3x10mm Round or Cap Head screws to attach to the Main Bracket.