Creality K1 SE Rear Cable Chain Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear mount and support bracket for adding a drag chain to your K1SE.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 129
- Makes
- 1
- Views
- 516
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of pererry’s Creality K1 SE Cable Chain Mount, which served as the foundation for this design.
📌 QUICK OVERVIEW
• Designed for Creality K1 SE
• Enables clean cable chain routing similar to the K1C
• Replaces the stock cable/PTFE arch with controlled routing
• Allows use of risers and top covers
• Works as part of a multi-model cable chain solution
This remix focuses on improved wire routing, mounting strength, and long-term durability while maintaining compatibility with the original concept. If you prefer the original design approach, I encourage you to check out the original model as well — it’s a solid solution.
This model is designed to be used alongside the following for a complete cable chain setup:
• Creality K1 Cable Chain Sagging Fix by ViniS
• Cable Chain Link with PTFE tube Guide by C3D Garage
• Creality K1SE Chain Link Riser by Protius (shameless self promotion)
🔧 PRINTING NOTES
Printed examples were done in PLA, but PETG or ABS may also be used if preferred.
Recommended settings:
0.4 mm nozzle
Standard layer heights (0.2 mm works well)
Default wall and infill settings
Supports:
• The main bracket and screw cover should be printed with supports.
• The rear support bracket and chain link can be printed without supports.
🔩 REQUIRED HARDWARE
Main Bracket:
• (2) M3 x 5mm Heat Set Threaded Inserts
Rear Support Bracket:
• (1) M3x10mm Flat Head screw (replaces factory screw to attach it to the frame)
• (2) M3x10mm Round or Cap Head screws to attach to the Main Bracket.