360 Degree Cooling & Cartographer Probe mount for Creality K1 HDM Linear Rail Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Much enhanced cooling and cartographer probe support for the HDM-K1 Full Linear Rail Conversion.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 487
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a toolhead cover for the HDM-K1 Full Linear Rail Conversion(235x235) that improves cooling performance by using a 360 degree duct design and directing the airflow more deliberately. It also comes with an option to mount a standard Cartographer v3 probe for bed meshing.
Print should be oriented with fan intake side on the buildplate. Version with carto mount must be printed with supports(manual so they don't generate inside the duct where you can't remove them). Supports heavily recommended for version without as well. Must be printed in ABS or better(even ABS-CF deforms after a while).
Instructions:
Use 2x M3x5(diameter)x4(length) Heatsets for carto mount.
Insert USB wire through hole and slot(remove PH2.0 connector first)
Install Cartographer with 2x M3x6mm BHCS and plug in
To install the cover, thread the hotend through the cooling hole first, before moving cover up to clip onto carriage and notches.
Known problems:
Collides with motor mounts at corners
Air comes out to the right(doesn't seem to affect cooling performance though)
Wire prevents you from fully separating cover from carriage