1 / 13
Mamiya RB67 Pinhole camera for 6x7, 6x8 film back holders — zdjęcie 1
1 / 13

Mamiya RB67 Pinhole camera for 6x7, 6x8 film back holders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compatible with all common RB67 film backs: 120/220, 6x4.5, 6x7, 6x8, Pro, Pro S, SD, Motorized

Ocena
0 / 5
Polubienia
29
Pobrania
97
Wydruki
1
Wyświetlenia
1061
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

21 May 2026 Update

  1. Fixed the clearances in the back mount — Pro SD backs now attach without any issues

  2. Removed the protruding “tooth” at the bottom of the mount that prevented early RB67 Pro backs from fitting properly

  3. Added a body version with embedded 1/4 nuts for tripod mounting. To insert the nuts, you need to add a pause in the slicer, place the nuts into the print, and then continue printing

  4. Added a body version with a tripod mount using a heat-set brass 1/4 threaded insert

  5. Added a front shutter cover version with an f/167 marking

     

Camera Features

  • Compatible with all common RB67 film backs: 120/220, 6x4.5, 6x7, 6x8, Pro, Pro S, SD, Motorized
    Tested with: 120 Pro S, 120 Pro SD, Motorized 6x8
     

  • There is a button that simulates the camera shutter release and signals the film back that the frame has been taken, allowing the advance lever to be unlocked for the next frame

  • Two tripod mounting points

  • Cold shoe for accessories such as a viewfinder, light meter, level, and others

     

Camera Parameters

  • Pinhole diameter — 0.3mm

  • F-stop — f/168

  • Angle of view:

    67 degrees horizontal for 6x7 (35mm eqv. for 135)

    73 degrees horizontal for 6x8 (24mm eqv. for 135)


Required parts

  • х5 М3 bolts 20mm lenght

  • x6 М3 nuts

  • x2 1/4" nuts or heat-set brass inserts for tripod mounting

  • x1 small spring, 4mm diameter

  • x1 Pinhole — 0.3mm


Print Recommendation

I used PLA filament and a 0.4 mm nozzle for most parts. Only minimal supports are required, and most supported areas will not be visible after printing.

To print the wheel with better detail and a cleaner look, I used a 0.2 mm nozzle.

The “Mamiya” logo was printed using a pause in the slicer: first, I printed the lower black base, then paused the printer, changed the filament to white, and continued printing. This resulted in a single part with a black base and white letters.

Tagi