1 / 13
Mamiya RB67 Pinhole camera for 6x7, 6x8 film back holders — image 1
1 / 13

Mamiya RB67 Pinhole camera for 6x7, 6x8 film back holders

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Compatible with all common RB67 film backs: 120/220, 6x4.5, 6x7, 6x8, Pro, Pro S, SD, Motorized

Rating
0 / 5
Likes
28
Downloads
93
Makes
1
Views
1,033
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

21 May 2026 Update

  1. Fixed the clearances in the back mount — Pro SD backs now attach without any issues

  2. Removed the protruding “tooth” at the bottom of the mount that prevented early RB67 Pro backs from fitting properly

  3. Added a body version with embedded 1/4 nuts for tripod mounting. To insert the nuts, you need to add a pause in the slicer, place the nuts into the print, and then continue printing

  4. Added a body version with a tripod mount using a heat-set brass 1/4 threaded insert

  5. Added a front shutter cover version with an f/167 marking

     

Camera Features

  • Compatible with all common RB67 film backs: 120/220, 6x4.5, 6x7, 6x8, Pro, Pro S, SD, Motorized
    Tested with: 120 Pro S, 120 Pro SD, Motorized 6x8
     

  • There is a button that simulates the camera shutter release and signals the film back that the frame has been taken, allowing the advance lever to be unlocked for the next frame

  • Two tripod mounting points

  • Cold shoe for accessories such as a viewfinder, light meter, level, and others

     

Camera Parameters

  • Pinhole diameter — 0.3mm

  • F-stop — f/168

  • Angle of view:

    67 degrees horizontal for 6x7 (35mm eqv. for 135)

    73 degrees horizontal for 6x8 (24mm eqv. for 135)


Required parts

  • х5 М3 bolts 20mm lenght

  • x6 М3 nuts

  • x2 1/4" nuts or heat-set brass inserts for tripod mounting

  • x1 small spring, 4mm diameter

  • x1 Pinhole — 0.3mm


Print Recommendation

I used PLA filament and a 0.4 mm nozzle for most parts. Only minimal supports are required, and most supported areas will not be visible after printing.

To print the wheel with better detail and a cleaner look, I used a 0.2 mm nozzle.

The “Mamiya” logo was printed using a pause in the slicer: first, I printed the lower black base, then paused the printer, changed the filament to white, and continued printing. This resulted in a single part with a black base and white letters.

Tags