Floor Heating Valve Knob (M30x1,5)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Floor Heating Valve Shutoff Knob (M30x1,5 thread). Can also be used to adjust.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 192
- Wydruki
- 5
- Wyświetlenia
- 660
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I needed an additional valve shutoff knob since one of the automatic ones was malfunctioning. Checked the dimensions and designed this knob.
Important information for printing: Depending on your tolerances, you will need to scale the design by 1-2 percent to get it to fit. For me, 100% was just too tight to get it on easily, and at 102% it was very easy to put on, so 101% would probably be perfect.
Print at a very low layer height (I printed at 0.1mm) to make sure the threads come out accurately. Print upside down.
Note: included gcode is for a Prusa MK3S+MMU2 at 102% scale of the model.
Note 2: My floor heating water does not get very hot (~45 Celsius) so it should be safe for PLA. If your heating system uses higher temperatures, consider printing with a material that is more heat-resistent.
Please leave a comment below if you use this design to let me know if it worked for you.