Spacer for Innogear Mic Arm Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer to reduce wobble on Innogear microphone arms
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this spacer to reduce wobble and improve rotation on my cheap microphone arm (Innogear MU056). It isn't super refined, but it seems to work (I'll update the model if I need to). It is only .4mm thick, so be careful when printing it, especially because it's designed for and has exclusively been tested in 95A TPU. This does not eliminate 100% of the wobble inherent in the terrible tolerances at the joint between the arm and the desk clamp, but it significantly softens wobble and rotation and seems to solve the issue with uneven resistance when turning the arm. It does seem to squeak a little, but I'm just dealing with it for now and I'll fix it later if I get too annoyed.
(sorry if the pictures are bad)