Prusa Mini ESP32 Camera Enclosure with Antennae Mount and LED Bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you followed the instructions to add an LED bar to your camera, this gives you a place to glue it!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
So if you followed the instructions from the Github, there's a blurb about mounting an LED strip that's ripped out of a USB bendy flashlight.
This is all well and good, but if you do this, the bar is just twisting in the wind.
I also liked the design that Jordan Smith made, except that the original LED flashes below the print bed. So for the first inch of the print, you cant see squat because the LED isn't illuminating the surface.
This solves that problem. It's even got a window in the top to allow you to pass through the board in case you forget to run the wires through BEFORE soldering them.
Friendly reminder that this one will need supports. However you choose to build it.
Note: be careful about what type of LED bar you use. As you can see in the picture of the ripped apart USB LED, there's no current limiting resistors which means it'll burn out!
