Funnel for Polymaker Polydryer Box Lid Desiccant Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A funnel to aid in filling the Polydryer Box Lid Desiccant Holder
- Ocena
- 4,75 / 5
- Polubienia
- 25
- Pobrania
- 221
- Wydruki
- 4
- Wyświetlenia
- 895
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Love the Polydryer Box Lid Desiccant Holder, but figuring out how best to fill it was a little difficult. I adapted the funnel I had from @Robinson by widening the whole assembly, cutting down the spout on one side, and adding a lip to hook under the sliding door to hold the funnel in place.
The Holder needs to be rotated and shaken to allow the desiccant to fall into the lower crevices, so I added a "pocket" so when the Holder is tilted upright the extra desiccant has somewhere to go. Then when the Holder is rotated back to the fill position the extra desiccant will fall down the funnel into the Holder.
Open the door, set the funnel in place, close the door over the lip (photo 3). Pour in desiccant not more than about halfway up the funnel, then rotate the Holder upright while shaking. Excess will fall into the pocket (photo 4). Roll it back down to the fill position and repeat. Generally takes two cycles to get the Holder packed full, but it's about 2/3 full after one which is probably fine. You want to end with the desiccant just under the lip opening (photo 5). Pull the door back just a little, remove the funnel (photo 6). Packed full as shown is 80-83g of desiccant for me.
Printed in Overture PETG White at 0.20 with painted-on Snug supports under the lip.
Only .3mf due to inability to export .stl with a necessary negative space modifier and I haven't learned how to use CAD yet.