1 / 1
Eric Bogosian (Or other image) Miniature Shrine with Hot-Swappable Text — zdjęcie 1

Eric Bogosian (Or other image) Miniature Shrine with Hot-Swappable Text

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A small shrine to Eric Bogosian or any other hueforge image, made to be used with a tealight. The text can be swapped.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
22
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
People
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a joke celebrity shrine I made for a friend of mine who had a crush on Eric Bogosian. It is meant to be humorous. 

While I included the picture of Eric Bogosian in the files, it is possible to use this model with any hueforge model that is 100mm wide and 2mm thick, and nearly any height. You can also use a normal picture with some kind of rigid backing, but where's the fun in that?

You will need a battery operated tealight, mine were around 36mm diameter or just under one and a half inches, but I included the step files if you need to adjust it for other lights.

I used 6mm by 2mm magnets for this print, but you can adjust with other magnets if needed.

Printing

I recommend making your hueforge print first. Once again, it needs to measure 100mm or so in the x direction, and 2mm or so in the z direction. For the included bogosian picture, I printed it with a layer height of 0.08mm, and you need to make the base model black, swap to grey at layer 7, gold at layer 12, and white at layer 17. 

For the rest of the print, I recommend a layer height of around 0.12mm for a good balance of details and speed, with an infill of 10% working pretty well for me.

The base of the shrine does not need supports, and I recommend not using them for the magnetic text plates either! You should pause the print and place the magnets mid print for the best results.

For the magnetic text plates, I recommend printing the model in white and black filament, pausing the print at layer 18 (Or where ever the top of the magnet holes are) inserting the magnet to ensure a clean finish and easy installation, and then swapping to black filament at layer 21. I installed the magnets with just a little superglue after the print finished.

Tagi