fcx24m badge reel winch and forward battery mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Super simple badge reel winch and forward battery holder for the fcx24m. no hardware needed.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Fix the biggest problem with the fcx24m, the rear biased weight distribution! Improve your climbing performance!
Add a super simple winch to your fcx24m with a cheep badge reel/holder and move your battery over the front axle.
All with one simple print! Clips to the frame, no screws or other hardware required.
Also included is a printable winch hook.
Designed around this badge reel: https://www.amazon.com/Retractable-Holder-Teachers-Students-Workers/dp/B0CLL846RB
other reels should work fine, as long as it has a 32mm diameter and is 10mm thick or less.
This reel is a little on the weak side for a badge reel, but it is strong enough to let the truck climb vertically if rigged right. I used a much stronger one during prototyping, and it was too strong and caused problems.
with the extra weight in the front, you will want top put a stronger spring on the front shocks, or add a little bit of pre-load with a 2mm zip tie above each spring, or a printed pre-load clip.
With an otherwise stock truck, the climbing performance is significantly improved, even without using actually using the winch.
I have only tested this on a D110, but the D90 should have the same dimensions in the front. your mileage may vary with the other camel trophy bodies and the tacoma.
May work with some scx24 chassis/body combos.
Note: I did have to raise my front body mount up one setting because the stock front tires were rubbing pretty bad out of the box, this may not fit without doing that, its a tight fit.