openGrid Magnetic Tool Rack Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
OpenGrid compatible mount for magnetic tool holders
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of a magnetic tool rack holder originally designed for Skadis, now brought over to openGrid! Uses the KYZ Design snaps; print two rings per snap and insert into the pockets on the snap. This provides a very robust hold which is needed to support the weight of both the magnetic strip as well as the tools attached.
The bracket is sized to fit a magnetic tool holder that is approximately 23 mm by 13 mm in cross sectional area. Measure your magnetic tool holder before printing to check if you have the similar dimensions! I used this U.S. General 18 inch holder available at Harbor Freight: https://www.harborfreight.com/18-in-magnetic-tool-holder-60433.html
I recommend printing this in PETG for the added strength and flexibility at 20% infill. It should be slightly snug. I ended up printing four mounts to hold my magnetic tool holder in place.