1 / 9
RaceGOW / Tiny Whoop Gate Parts / Schedule 40 PVC Connectors Home Depot (US) — zdjęcie 1
1 / 9

RaceGOW / Tiny Whoop Gate Parts / Schedule 40 PVC Connectors Home Depot (US)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connectors and gate stand for RaceGOW parts or other FPV gates using Schedule 40 1/2" PVC.

Ocena
0 / 5
Polubienia
4
Pobrania
39
Wydruki
0
Wyświetlenia
246
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I didn't want to buy a whole bunch of PVC connectors from a home improvement store and I didn't want to 3D print connectors based on the OD of the PVC. These parts are remixed from the following model because the original model did not fit the schedule 40 I bought from Home Depot in the US.

https://www.printables.com/model/1025396-racegowtinywhoop-budget-race-gates-for-20mm-pvc

These parts will snuggly, but not permanently fit into both of the following schedule 40 1/2" PVC from Home Depot (United States):

Please reference the RaceGOW website (https://www.racegow.com/)for quantities of each connector needed. The RaceGOW website says 6x Tee Connectors ("RaceGOW_3-Way_Flat" in my list) but I would also recommend printing 6x "RaceGOW_3-Way-Corner". I ended up printing many of each of these parts because I wanted to make bigger tracks and additional, freestanding gates. I also added "caps" to put on the ends of the PVC sections. I printed all connectors in black PLA to add contrast to the white PVC. I printed the stands in white PLA just because I ran out of black when I wanted to print these.

Stand Notes:

  • There is a purposeful air vent hole in the bottom so there isn't a vacuum when trying to install/remove the PVC.

  • I used scarf joints so the PCV was a smoother install.

  • Unfortunately, I can only print 1 stand at a time on my print bed, but only takes ~3hrs to print one. I didn't want to scale it down to fit more because I wanted the stand to have a wide enough base to support larger gates without falling over.

I'm just getting into 3D Modeling, so I created the stand directly in PrusaSlicer....forgive me, but it adds the flexibility to change sizes very easily.

PRINTING INSTRUCTIONS:

  • Prusa i3MK3S+

  • Sunlu PLA (go nuts with colors!)

  • 0.2mm layer height

  • No need to scale if fitting into the 1/2" PVC linked above, but good idea to print the "RaceGOW_SmallCap" as a test. Should fit snug. might wear out over repeated install/removals, so might be worth printing in a different material.

  • 15% Gyroid infill for strength

  • 2 Perimeters

  • Scarf joints on gate stand only.

  • Grid supports on "RaceGOW_6-Way" only using paint on supports for overhangs only.

  • Paint on fuzzy skin (0.3mm thick and 0.3mm distance) for the outside of the gate stand tube to give grip/texture for installing/removing.

  • Included the 3mf files at the beginning of the parts list if you need to make changes.

Good luck and happy whooping!

Tagi