Car holder - TrueLife Nannycam
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EN: NannyCam car headrest holder, best printed from CF/GF filament. CZ: Držák NannyCam na opěrku, ideálně tisk z CF/GF f
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
TrueLife NannyCam holder designed for in‑car use. When the baby is sleeping in the car in the driveway, it’s useful to monitor them with a camera. I power the camera using a 10 000 mAh powerbank.
The holder snaps onto the headrest rod. I measured rods in three different cars (Honda, Renault, Citroën) and all had a diameter of 12.6 mm, so the mount is designed primarily for this size. It can also clip onto a thicker rod (tested up to 20 mm), but not onto thinner ones.
For best results, I strongly recommend printing from carbon‑fiber‑ or glass‑fiber‑reinforced filament to prevent creep. Standard PLA works at first, but it will lose clamping force after a few months, especially in summer heat.
Do NOT leave it clipped in the car while driving. It may become dangerous in the event of an accident
Designed to 3 perimeter print with 0.4mm nozzle